Adjusting Altitude; Enabling Dew Prevention - Xerox Phaser 7100 Service Manual

Adjusting Altitude

Adjust Altitude procedure adjusts the altitude to match that of the location where the printer is
installed. If the altitude setting is incorrect, it can cause print-quality problems.
Procedure
On the Control Panel, press Menu.
1.
Press Down Arrow and navigate to
2.
3. Press Down Arrow and navigate to
4. Press Down Arrow and navigate to
5. Press Up/ Down Arrow to select the altitude for the location of the printer, and press OK.
• 0 to 1000m ASL
• 1001 to 2000m ASL
• 2001 to 3000m ASL
• 3001m ASL & above
6. Press Menu to return to the

Enabling Dew Prevention

Moisture can condense inside a printer where the humidity is above 85% or when a cold printer is
located in a warm room. Condensation can form in a printer after it has been sitting in a cold room that
is heated quickly.
Procedure
On the Control Panel, press Menu.
1.
Press Down Arrow and navigate to
2.
Press Down Arrow and navigate to
3.
Press Down Arrow and navigate to
4.
5. Use Up/ Down Arrow and select Enabled, and press OK.
6. Press Menu to return to the
Xerox Internal Use Only
Menu, and press OK.
Admin
Image Quality, and press OK.
Altitude Adjustmt, and press OK.
Ready to Print screen.
Menu, and press OK.
Admin
Settings, and press OK.
System
Prevention, and press OK.
Dew
Ready to Print screen.
Phaser 7100 Service Manual
Maintenance
6-21