TOHATSU MD 30B2 Service Manual page 202

Lower Unit
4. Attach shim 0 used on the reverse (C) gear 9 to the
gear.
Use a suitable press to install reverse (C) gear 9.
Clean reverse (C) gear bearing installation face
and apply gear oil before installation.
Bevel Gear Bearing Install Tool q :
P/N. 3C8-72719-0
GEAR
GEAR GEAR
16) Disassembly of Propeller Shaft Ass'y
1. Remove push rod 1 and steel ball 2.
2. Put a bladed screw driver into one of clutch pin snap 3
end, and take the snap out from the clutch groove while
winding it.
6-24
q
9
7 Bearing
Do not reuse.
3
7
6
5
2
1
4
3 Clutch Pin Snap
Do not reuse.
3 Clutch Pin Snap
Do not reuse.
GEAR GEAR
GEAR
9
0
0
7
GEAR GEAR
GEAR
3
TLD D30/40/50B2 2013