Lower Unit
4) Disassembly of Cam Rod
1.
Remove stopper, pull out cam rod bushing, and take out
cam rod from gear case.
When removing cam rod bushing, put a bladed
screw driver into groove of the bushing and pull
out while lifting it.
2.
Remove shift rod joint 1 and clutch cam 2.
6
2
Spring Pin Tool A 3 (ø3.0) :
P/N. 345-72227-0
3.
Remove O ring 5 from cam rod bushing 6.
5) Inspection of Clutch Cam
1.
Check the part for wear and damage.
Replace if necessary.
Check especially for wear on the face a that
scrapes against push rod and flaws on the
circumference b.
6-14
1
3
1
6
2
Spring Pin Tool A 3 (ø3.0) :
P/N. 345-72227-0
Spring Pin Tool A 4 (ø3.5) :
P/N. 369-72217-0
5
6
6 O Ring
Do not reuse.
b
3
4
5
6
a
TLD D30/40/50B2 2013