Inspect On Of Ptt Un T - TOHATSU MD 30B2 Service Manual

Service Information
6) Fuel Line
Check that fuel tank contains sufficient amount of gasoline,
fuel line is connected and does not leak.
Supply only unleaded regular octane gasoline
(Pump posted 87 Octane / Research octane
rating of 91 or higher) into fuel tank. Never
use fuel mixed with oil. Use of fuel mixed
with engine oil will cause engine trouble.
7) Installation of Outboard Motor (Rigging)
Check that outboard motor is fixed on the hull with
installation bolts and nuts securely (For tiller handle model
: Tighten the clamp screw too.). Check location of anti-
ventilation plate relative to boat bottom.
Test-run to determine the best installation height.
Anti-ventilation plate standard position a :
10 - 30 mm (0.4 - 1.2 in) below boat bottom
8) Inspection of PTT Unit
1. Operate PTT switch to check that outboard motor tilts up/
down smoothly.
2. Operate PTT switch to check that tilting up/down outboard
makes no abnormal noise.
3. Tilt up outboard motor and steer fully to the right and left
to check that cables and hoses do not interfere with each
other and with any part of hull.
4. Tilt outboard motor down to check that trim meter indicates
the lowest position.
1-12
CAUTION
a 10 30 mm (0 4 1 2 in)
a
TLD D30/40/50B2 2013