TOHATSU MD 30B2 Service Manual page 117

2. Apply two stroke engine oil to cylinder inner wall 3, piston
periphery, and piston rings, and install piston ass'y to the
cylinder so that "UP" mark of the piston head is at the
pulley side.
Piston Slider 4 :
P/N. 3T5-72871-0
2st OIL
2st
10) Installation of Compressor Housing Ass'y
1. Attach dowel pins 2 to compressor cylinder 1.
2. Install compressor housing ass'y 3 and gasket by using
bolt 4.
Put crank pin into connecting rod big end and
install the assembly while shaking crank shaft a
little.
Compressor Housing Bolt 4 :
6N·m (4 lb·ft) [0.6kgf·m]
3. Install head 5, reed valve ass'y 6 and gasket 7 by using
bolt 8.
Be careful of the orientations of reed valve ass'y
and gasket when installing them.
Degrease both mating faces of compressor head
gasket and valve seat gasket before installing
them.
Cylinder Head Bolt 8 :
9N·m (7 lb·ft) [0.9kgf·m]
TLD D30/40/50B2 2013
1
2st
2st OIL
3
6
7
5
8
4
3
4
4
2
1
7
4-37