TOHATSU MD 30B2 Service Manual page 109

4. Attach upper grommet 8 and cable terminal grommets 9.
Grommets 8, 9 :
Genuine Engine Oil
2st
Attach black wire 0 ( − ) and red wire q ( + ) of cable
terminal to FFP case.
Be sure to connect the wires to their corresponding
flat terminals ( − and + ).
5. Connect FFP cords w to their corresponding terminals 0
and q.. (Y... Yellow − L... Blue + )
Push down cables terminals to connect terminals
securely. Be careful that the cords are not caught.
Attach cord cover t and clamp y to the body by using
spacer (washer) e and bolt r.
FFP Bolt r :
3 N·m (2 lb·ft) [0.3 kgf·m]
6. Attach cable terminal grommet (upper) u, put seal ring (O
ring) i and upper case 3 and then, secure the parts with
bolts o.
Cable Terminal Grommet Upper u :
Genuine Engine Oil
2st
FFP Case (Upper) Bolt o :
3.2 N·m (2.3 lb·ft) [0.32 kgf·m]
12) Removing Fuel Pump
1. Remove Low pressure fuel pump.
Disconnect hose from vapor sepalator and fuel
filter.
TLD D30/40/50B2 2013
u
2st
2st OIL
q
0
9
2st
2st OIL
t
r
y
e
o
i
8
2st
2st OIL
4
w
4-29