TOHATSU MD 30B2 Service Manual page 230

Lower Unit
5. Connect shift rod joint 3 and shift rod 4, and drive in
spring pin 5.
· Do not reuse spring pin.
· Replace with new one when removed.
Spring Pin Tool B 6 : (ø3.0)
P/N. 345-72228-0
6. Attach propeller and tighten propeller nut 7 to specified
torque.
· Before removing or installing propeller, be
sure to remove stop switch lock plate.
· When removing or installing propeller, do
not handle propeller with bare hands.
· Put a piece of wooden block between anti-
ventilation plate and propeller to prevent
rotation of propeller when removing or
installing propeller.
Propeller Nut 7 :
35 N · m (25 lb · ft) [3.5 kgf · m]
7. Attach split pin 8.
If propeller shaft pin hole and propeller nut
pin groove do not align, additionally tighten
the nut until they align.
8. Fill gear case with gear oil to specified level.
Refer to "Replacement of Gear Oil" in Chapter 3.
Perform "Inspection of Gear Case (Air Leakage)"
in Chapter 3 if necessary.
6-52
CAUTION
CAUTION
4
3
5 Spring Pin
Do not reuse.
8 Split Pin
Do not reuse.
5
6
8
7
TLD D30/40/50B2 2013