Maintenance
7) Inspection of Drive Belt
1.
Remove ring gear cover.
Make sure to check engine stopped.
2.
Remove air compressor to check drive belt for wear
and damage on the inner and outer faces while turning
flywheel clockwise. Check if oil or dirt is adhered to the
belt.
Replace with new one if any of the problems exists.
· For removing of air compressor, refer to
"Removing Air Compressor", "Installing Air
Compressor" in Chapter 4.
· For replacement of drive belt, refer to
"Removing Flywheel" in Chapter 5.
3-8
DANGER
TLD D30/40/50B2 2013