Cowl, Bracket and PTT Unit
5.
Install water pipe to drive shaft housing, and attach gasket
after confirming that dowel pins 9 are on the drive shaft
housing.
6.
Check that drive shaft housing dowel pin is placed and
secured to engine base properly.
Check that water pipe is at joint of engine base.
7.
Install engine base 3 to drive shaft housing 0 by
tightening installation bolts to specified torque.
Engine Base Bolts :
6 N · m (4 lb · ft) [0.6 kgf · m]
7-30
9
TLD D30/40/50B2 2013
9
3
3
0
0