4.
Screw cable joint 9 on the tip of remote control cable by
approximately 10mm.
The screw-in distance of cable joint, 10 mm, is
equivalent to approximately 9 threads.
5.
Shift cable is the one of which tip is moved when remote
control lever is set to forward (F) side until it stops once
(approx. 32 degrees).
6.
Set remote control lever to neutral (N), and check that
neutral throttling lever is at full close position.
7.
Set advancer arm to full close position.
• Check that advancer arm 0 is surely in contact
with full close side stopper q.
• Also check and adjust that advancer arm is
surely in contact with full open side stopper.
TLD D30/40/50B2 2013
9
Full open
Full close
Neutral
Throttling Lever
0
q
10
10-11