TOHATSU MD 30B2 Service Manual page 107

7) Installation of Vapor Separator Ass'y
1. Reverse the removing steps.
1 Vapor Separator Ass'y
2 Tighten bolts.
Bolts 2 :
6 N·m (4 lb·ft) [0.6 kgf·m]
8) Removing FFP* Ass'y
* FFP : Fuel Feed Pump
1. Remove parts in the order described below.
Disconnect FFP connector 1, loosen hose joint 2, and
then remove fuel hose ass'y.
2. Remove following hoses.
Fuel Return Hose 3
Fuel Hose 4
Vapor Return Hose 5 : FFP → Vapor Separator
3. Loosen two bolts 6 and remove FFP.
Use waste textile to catch fuel that spills from
each hose when it is disconnected.
4. Remove low pressure side fuel pump.
9) Disassembly and Inspection of FFP
1. Loosen upper case 1 securing bolts and take out FFP
from FFP case 2.
2. Inspection of FFP
Check if any contamination is found in the case 2.
Clean if necessary.
3. Check if any corrosion found on the FFP body 3, or upper
or lower resin part is damaged or cracked, and clean or
replace if necessary.
TLD D30/40/50B2 2013
: Air Rail → FFP
: Vapor Separator → FFP
2 2
2 2
3 3
1 1
4
1 1
2 2
4
5 5
6
1
3
2
4-27