Cowl, Bracket and PTT Unit
4.
Check if drive shaft housing is distorted.
Place the housing on the surface plate and use dial gauge
to measure distortion on the upper face of the housing.
Replace if the difference is over 0.228mm (0.0090in) on
each measuring point.
Use of distorted drive shaft housing may
cause severe wear of drive shaft spline
which may lead to damage on the crank
shaft spline.
8) Assembly of Drive Shaft Housing Parts
1.
Install exhaust pipe 1 and gasket 2 to engine base 3
and tighten bolts 4 to specified torque.
Exhaust Pipe Bolts 4 :
13 N · m (9 lb · ft) [1.3 kgf · m]
7-28
CAUTION
3
2
4
1
TLD D30/40/50B2 2013