Others - TOHATSU MD 30B2 Service Manual

Maintenance
3. Check following parts.
7 Bolts : M8 4 pcs.
8 Washers 4 pcs.
9 Pump Case (Upper)
0 Pump Case Liner
q Pump Impeller → Replace with new one.
w Key
e Seal → Replace with new one.
r Guide Plate
t Gasket → Replace with new one.
y Dowel Pin
u Pump Case (Lower)
i O Ring
o Oil Seals
p Shim
Inspection
1. 6 - t : Replace with new one if worn or damaged.
o Be sure to install oil seal in correct orientation.

9. Others

1) Replacement of Anode
1. Dirt on Anode and Trim Tab
Check if grease or oil is adhered to the components. Clean
if necessary.
Anode protects outboard motor from
galvanic corrosion. Do not paint or apply
grease or oil to anode. Doing so disables
the anode.
· Anodes 1 are used in the exhaust cover,
cylinder body, clamp bracket and gear case trim
tab.
· When it is necessary to disassemble outboard
motor for inspection of anode, refer to
disassembly procedure described in this manual.
Reduction of anode volume can lead to outboard
motor body damage.
3-18
CAUTION
7
8
9
0
w
e
u
i
o
p
o
Do not reuse.
qtio
q
r
t
y
1
1
TLD D30/40/50B2 2013