TOHATSU MD 30B2 Service Manual page 224

Lower Unit
34) Assembly of Lower Unit Parts
1. After installing forward (A)gear with taper roller bearing 1,
install drive shaft ass'y 2, pinion (B) gear 3 and pinion
(B) gear nut 4, and tighten the nut to specified torque.
2
1342
1342
1
OBM
OBM OBM
GEAR
GEAR GEAR
1342
1342 1342
· Tighten the nut by using a drive shaft socket 5
and a wrench and turning the wrench clockwise.
Cover the wrench 6 with rag to prevent it from
hitting the case directly.
· This work can be made easier when the opening
of gear housing of propeller shaft side is faced
upward and fixed horizontally with a holder.
· Before tightening pinion (B) gear and nut, apply
ThreeBond 1342 to the thread.
· Degrease taper area of drive shaft pinion (C)
gear installation section and thread of gear nut
completely.
6-46
3
4
2
1342
1342
1
5
3
4
6
TLD D30/40/50B2 2013