TOHATSU MD 30B2 Service Manual page 349

5) Filling Fuel System
Fill the fuel system as described below before initially starting
new engine, after engine exhausted fuel, or after draining fuel
from engine.
To prevent damaging to fuel pump, fill
engine's fuel system with fuel. If not, the
fuel pump operates without fuel during
priming of oil pump.
1. Squeeze priming bulb of fuel hose until it becomes stiff.
2. Set key switch to "ON" position for three seconds to
operate electric fuel pump.
3. Return key switch to "OFF" position and squeeze priming
bulb again until it becomes stiff. Set key switch to "ON"
position for three seconds again. Repeat these steps until
primary bulb of fuel hose becomes stiff.
6) Filling Oil Tank
Note: Oil tank capacity is 2.0 L (0.53 gal).
1. Remove top cowl, and then turn oil tank cap 1 counter
clockwise to remove.
2. Pour specified quantity of engine oil into oil tank. Do not
overfill. Oil level should be below filler neck a.
3. Put oil tank cap on the tank and tighten. Reinstall top cowl.
a : Oil Upper Level 4.3L (1.14gal)
TLD D30/40/50B2 2013
WARNING
1
a
10
10-7