TOHATSU MD 30B2 Service Manual page 158

Power Unit
25) Disassembly of Crank Shaft
1. Remove main bearing (Lower).
Remove "C" ring 1 and pull out spacer 2.
Remove main bearing (lower) 3 by using universal puller
plate and universal puller.
Universal Puller Plate 4 :
3AC-99750-0
Puller 5 : Commercially Available Item
Protecting Plate 6
• Use 25 mm (0.984 in) protecting plate.
• Set protecting plate 6 to main bearing side for
protect the damage of oil pump drive gear.
26) Removing of Drive Pulley
Fully move main bearing (upper) 1 to crank web
side for set the tool.
1. Install drive pulley puller ass'y 2 to drive pulley 3.
Drive Pulley Puller Ass'y 2 :
3T5-72890-0
Add grease to top of crankshaft and thread part of
the plate.
5-36
3
2
4
5
6
1 1
3
1
2
TLD D30/40/50B2 2013