TOHATSU MD 30B2 Service Manual page 203

3. Pull out clutch pin 4, and remove clutch spring retainer
5, clutch spring 6, and clutch by referring to the figure.
· W h e n r e m o v i n g c l u t c h p i n , w e a r
protective glasses, and do not point
opening of propeller shaft to your face
or body while holding the propeller shaft.
Clutch pin or spring holder may fly out
very quickly.
· Install push rod 1, and pull out pin 4
while pushing propeller shaft onto a plane
to prevent retainer 5 and spring 6 from
flying out.
4. After taking out clutch spring retainer 5 and clutch spring
6, remove clutch 7 from propeller shaft.
17) Inspection of Propeller Shaft Ass'y
1. Check propeller shaft for bend, wear and damage.
Replace if necessary.
2. Measure propeller shaft runout.
Runout Limit :
0.05 mm (0.0020 in)
3. Check clutch claw b and push rod c for crack and wear.
Replace if necessary.
TLD D30/40/50B2 2013
WARNING
7
a
a Supporting Points
c
b
4
1
6
a
6-25