5.
Set the lever of pressure gauge ass'y to position b to
relief pressure, after engine stopping.
6.
Remove pressure gauge ass'y and attach cap.
6) Inspection of Fuel Pressure
When attaching pressure gauge ass'y,
cover the joint of inspection valve and
gauge with rag to prevent spread of fuel
that leaks.
Screw in the pressure gauge carefully until
it is set securely.
1.
Remove cap.
2.
Attach pressure gauge ass'y to fuel pressure inspection
valve 1.
Pressure Gauge Ass'y:
P/N. 3T5-72880-0
3.
Set the lever of pressure gauge ass'y to position a.
4.
Measure fuel pressure while idling the engine or cranking
for 15 seconds.
Do not move the lever of the gauge during
the measurement. Moving the lever causes
highly pressurized fuel to blast out, which
is very dangerous.
The fuel pressure reduces gradually after stopping
the engine or cranking.
Fuel Pressure : Specified Value
Measured Air Pressure + 0.07 MPa (10.1 psi) [0.71 kgf/cm
5.
Set the lever of pressure gauge ass'y to position b to
relief pressure, after engine stopping.
When depressuring, collect fuel that spills
from the tip of the gauge.
6.
Remove gauge.
Be careful not to let the fuel in the gauge
leak when removing the gauge.
7.
Attach the cap.
TLD D30/40/50B2 2013
CAUTION
WARNING
] ±10%
2
CAUTION
CAUTION
a
b
1
3
3-7