TOHATSU MD 30B2 Service Manual page 114

Fuel System (TLDI)
4) Disassembly of Compressor Housing
1. Remove oil seal 1 and bearing 2.
Heat compressor housing to 60 to 70 degrees
Centigrade (140 to 158 degrees Fahrenheit) by
using hot water before removing bearing 2.
Do not reuse removed bearing.
Heating of compressor housing can also be made
by using a heat gun or heat lamp.
5) Inspection of Reed Valve
1. Check if reed valve is bent, damaged or worn.
Replace reed valve ass'y if the reed valve gap is over the
specified limit.
Gap of Reed Valve at the Tip a :
0.2 mm (0.008 in)or less
6) Inspection of Cylinder and Piston
1. Clean compressor cylinder, compressor head and
compressor housing, check the parts for cracks damages.
Replace if necessary.
2. Check cylinder wall for wear or scuffing.
Replace if necessary.
3. Clean piston and check for crack and damages.
Replace if necessary.
4. Check that connecting rod small end moves smoothly.
Replace if necessary.
4-34
CAUTION
1
2
2
Do not reuse
1 2
a
a
TLD D30/40/50B2 2013