Cowl, Bracket and PTT Unit
14) Disassembling Clamp Bracket
· When disassembling clamp bracket, be
sure to fully tilt up outboard motor. If
outboard motor is fully tilt down it can
pop out spring suddenly and result in
severe injury.
· When tilting up outboard motor without
power unit installed, be careful to
operate tilt lock lever to prevent swivel
bracket rise up easy.
1.
Remove drive shaft housing, steering shaft, thrust rod
and PTT unit/Gas shock absorber before beginning this
procedure.
2.
Remove ground cable 1 on the swivel bracket.
3.
Loosen nut 2 of swivel bracket shaft.
4.
Remove swivel bracket shaft with spring and swivel
bracket.
7-36
WARNING
2
2
2
TLD D30/40/50B2 2013
1
1
1