Top Cowl - TOHATSU MD 30B2 Service Manual

Maintenance

3. Top Cowl

1) Inspection of Top Cowl
1. Push top cowl using both hands to check for looseness
and state of closing. Replace top cowl if cracked or
damaged.
2) Oil Filter and Oil Tank
1. Only clean if debris, water, or contamination is present.
If cleaned then you must bleed the oil system.
2. Reinstall oil tank and fill the tank with fresh oil.
3. Set outboard motor to vertical position, and check amount
of engine oil.
Refer to "Check quantity of engine oil" in Chapter 1.
Replenish if necessary.
3) Air Bleeding
Wipe off completely leakage oil by rag.
1. Visually check if any air is found in the oil line from oil tank
to cylinder block, and if any air is found, bleed the air by
using the following procedure.
2. Fill oil tank.
3. Loosen the air breading screw 1 and flows oil from the
inlet pipe 2 when containing no air bubble flows out.
Tighten screw when containing no air bubbles.
å From Oil Filter
3-4
CAUTION
1
å
2
TLD D30/40/50B2 2013