TOHATSU MD 30B2 Service Manual page 265

13) Removing PTT Unit/Gas Shock Absorber
1. Fully tilt up outboard motor and lock with tilt stopper 1.
Be sure to lock outboard motor with tilt
stopper after tilting up. Leaving outboard
m o t o r w i t h o u t l o c k i n g m a y l e a d t o
accidental descent due to reduction of PTT
hydraulic pressure.
• If PTT unit will not operate, open manual valve
and lift up outboard motor with hands.
• When manual valve is opened, be sure to
tighten it with specified torque after tilting up
outboard motor.
Manual Valve :
1.8 N·m ( 1.3 lb·ft ) [ 0.18 kgf·m ]
2. Remove thrust rod 2.
3. Remove bolt 3 and remove cylinder pin (upper) 4.
4. Perform tilt down operation to retract tilt rod a little.
5. Disconnect PTT motor leads from PTT solenoid. (PTT
model)
6. Remove screw 5 and clamps 6, and pull out PTT motor
leads. (PTT model)
7. Remove bolt 8 and ground lead 9 from bottom of PTT unit
7 / gas shock absorber 0.
8. Remove "C" ring q, and then cylinder pin (lower) w.
Hold PTT unit or gas shock absorber with a
hand, and use another hand to pull out cylinder
pin (lower) and remove PTT unit rearward.
9. Remove PTT unit 7 or gas shock absorber 0.
10. Remove bushings r, t, y and u.
TLD D30/40/50B2 2013
WARNING
1
3
4
r
t
t
y 7
u
y
ガスアシスト
8
9
0
u y
y
9
8
2 Thrust Rod
3 Bolt
4 Cylinder Pin (Upper)
5 Screw
6 Clamps
7 PTT Unit
8 Bolt
9 Ground Lead
0 Gas Shock Absorber
q "C" Ring
w Cylinder Pin (Lower)
r t y u Bushings
6
5
6
5
7 7
2
w
q
7-35