Installation of an outboard motor at higher position
can cause the matters described below.
1) Suck in air from a cooling water inlet, and
overheat can easily.
2) Deterioration of steering feeling.
3) Propeller can easily run above water surface
(over-revs) during planning or when the boat is
heavily loaded.
a : Outboard installation height is the distance from
the boat's bottom to upper edge of outboard motor
transom bracket.
4) Hanging Outboard Motor
Use hanger installed on the engine.
5) Installation of Outboard Motor
1.
Put the outboard motor installation template on the
transom.
Align center line of template with center line of
transom accurately.
2.
Mark up the transom with four 12.5 mm (0.49 in) mounting
holes and drill.
Drill at right angle to transom surface to align the
transom holes with outboard motor's transom
bracket holes accurately.
TLD D30/40/50B2 2013
a
10
10-5