TOHATSU MD 30B2 Service Manual page 350

Rigging
r/min
8) Priming Oil Pump
After installing outboard motor, prime oil pump before initially
starting the engine. The priming removes all air bubbles
contained in the pump, oil feed hose and internal oil passage.
Refer to "Air Purging" in Chapter 4.
4. Connections to Outboard Motor
1) Steering Cable
Cable arranged on the starboard side
1. Apply thin coat of grease to entire area of cable end.
2. Run steering cable into tilt tube.
3. Tighten nut to specified torque.
Nut :
48 N · m (35 lb · ft) [4.8 kgf · m]
B e s u r e t o a t t a c h d r a g l i n k s e a l r i n g 1
3F3-84908-0.
10-8
LIT
LIT
1
TLD D30/40/50B2 2013