TOHATSU MD 30B2 Service Manual page 341

Wait another 5 to 10 seconds, again pull the red knob on the
3
stop switch for about 0.5 seconds, then release the switch.
Resetting of TPS and ECU is completed when the buzzer "Beeps" three
4
times approximately 5 seconds after the knob of stop switch is returned to
original position.
Next, set the key switch to the Off position, confirm that the
5
throttle (advancer arm) is at the fully closed position, then turn
the key switch to the On position.
ResetProcedureChart
ON
1
Key switch
OFF
ON
Stop switch
OFF
1
Disconect the stop switch
lock.
TLD D30/40/50B2 2013
Beeping stops
2
1 5-10 5-10
second seconds seconds
12
Pull the red knob for 0.5
seconds and release.
3 4
5
seconds
4
Three short beeps
indicate successful TPS
and ECU reset Procedure.
5 10
-
Seconds
0 . 5
S e c o
n d s
5
Seconds
Beep ！ ！
Beep ！ ！
Beep ！ ！
ON
OFF
5
5
Confirm advancer
arm is at the fully
closed position
9
9-45