Power Unit
8) Removing Starter Motor
1.
Remove starter motor securing band and securing bolts
(M8, 4 pcs.) on the upper surface, and then, starter motor
from bracket.
• Disconnect grounding wire from air chamber.
• Loosen FFP bolts.
9) Removing Cord Ass'y and ECU
1.
Disconnect overheat sensor connector located on the
cylinder block and the air compressor.
2.
Disconnect fuel injector connector while pushing hook of
the connector. Repeat this step for three cylinders.
3.
Remove ignition coil connectors while pulling locks of the
connector. Repeat this step for three cylinders.
Remove ground wires from each ignition coil.
5-22
TLD D30/40/50B2 2013