4.
Positioning Upper Bearing and Main Bearing
• Attempt to move each bearing lightly to check if
dowel pin is in the hole snugly.
• Each bearing is provided with a bearing
lubrication hole 2 on the opposite side of knock
hole to check the location.
34) Assembly of Crank Case Halves
1.
Degrease crank case and cylinder mating faces.
2.
Apply sealing agent to crank case's mating surface.
• Be careful not to allow sealing agent to squeeze
out.
• Apply sealing agent on the area inside of the bolt
holes continuously in width of approximately 1
mm as shown.
518
518
518
3.
When installing crank case, check position of dowel pins
a.
TLD D30/40/50B2 2013
518
518
518
a
a
2
2
5
a
a
5-45