TOHATSU MD 30B2 Service Manual page 206

Lower Unit
20) Disassembly of Drive Shaft Ass'y
1. Remove outer shim 1.
2. Remove drive shaft spring 2.
3. Remove taper ball bearings 3 by using press and
universal puller 4.
Do not reuse removed bearing.
Be sure to replace with new one.
· Check bearing for play or deflection before
removing, and replace if necessary.
· When putting universal puller plate on the
bearing, hook the tip of puller's claw on the inner
race of bearing correctly.
Universal Puller Plate 4 :
P/N. 3AC-99750-0
21) Inspection of Drive Shaft
1. Check drive shaft for bend and wear.
Replace if necessary.
2. Measure drive shaft runout.
Runout Limit :
0.3 mm (0.013 in)
22) Inspection of Pinion (B) Gear
1. Check gear teeth and dog for crack, wear and damage.
Replace if necessary.
6-28
CAUTION
3 Bearings
Do not reuse.
3 Bearings
Do not reuse.
a
a Supporting Points
1
3
4
2
3
4
a
TLD D30/40/50B2 2013