TOHATSU MD 30B2 Service Manual page 227

37) Installing Propeller Shaft Housing Ass'y
1. Attach O ring 2 to propeller shaft housing 1.
Apply OBM grease to O ring.
2. Attach steel ball 4, clutch push rod 5 and washer 6 that was
removed when disassembling to propeller shaft 3.
3. Install propeller shaft 3 to propeller shaft housing 1, and
install the assembly to gear case.
· Install propeller shaft housing to gear case
securely, and tighten the securing bolts after
confirming that O ring is set in the case properly.
· Apply ThreeBond 1342 to thread of propeller
shaft housing installation bolts.
D30/40/50
Propeller Shaft Housing Bolts :
6 N · m (4 lb · ft) [0.6 kgf · m]
1342
1342 1342
WD50 only
38) Measurement of Propeller Shaft
Play and Selection of Washer
Thickness
Before measuring propeller shaft play,
adjust backlash between forward (A) and
pinion (B) gears and reverse (C) and pinion
(B) gears.
R e f e r t o " M e a s u re m e n t o f B a c k l a s h
between Forward (A) and Pinion (B) Gears
and Shim Selection" and "Measurement of
Backlash between Pinion (B) and Reverse
(C) Gears and Shim Selection" in Chapter 6.
1. Assemble lower unit parts in accordance with procedure
described in "Assembly of Lower Unit Parts" on Chapter 6.
Measure play of propeller shaft in forward and reverse
2.
directions.
TLD D30/40/50B2 2013
CAUTION
3
6
2
1
OBM OBM
OBM
When bolts are reused
1342
1342
2 O Ring
Do not reuse.
WD50
Propeller Shaft Housing Bolts :
13 N · m (9 lb · ft) [1.3 kgf · m]
5
4
6
6-49