TOHATSU MD 30B2 Service Manual page 105

2) Installation of Fuel Hose Ass'y
Reverse the removing steps.
Fuel Filter Band Securing Bolt 4
Fuel Filter Band Bolt 4 :
12 N·m (9 lb·ft) [1.2 kgf·m]
Nut for attaching to FFP
Fuel Hose Ass'y Nut 7 :
15 N·m (11 lb·ft) [1.5 kgf·m]
Do not tighten with excessive torque. The part
may be damaged.
3) Draining Fuel from FFP Vapor Separator
1. Decompress fuel and air pressures.
Compressed fuel and/or air may spurt if it
is not decompressed.
2. Loosen air vent screw 1, and then, drain screw 2 to drain
fuel from vapor separator and collect it in a container.
3. Disconnect hose 3 at vapor separator side to drain fuel
from FFP and collect it in a container.
4) Removing Vapor Separator
Drain fuel from vapor separator.
1. Pull out following hoses.
Vapor Exhaust Hose 1 : Vapor Separator → Throttle Body
Vapor Return Hose 2
Fuel Inlet Hose 3
Fuel outlet Hose 4
2. Loosen the bolt 5, and then remove vapor separator
TLD D30/40/50B2 2013
WARNING
: FFP → Vapor Separator
: Fuel Pump → Vapor Separator
: Vapor Separator → Fuel Pump
2 2
1
2
3
5
3 3
4
1
1 1
2 2
5
4 4
4-25