Table of Contents
Advertisement
6 Multi-Button
Upload PLC Program is selected.
Source:
Specify the source PLC connected to the MICRO/I. The PLC type is configured in the Project Settings
dialog box, on the Communication Driver Network tab. For details, refer to Chapter 4 "3.4
Communication Driver Network Tab" on page 4-52.
Interface:
If serial interface is selected for Interface.
Slave Number:
External Device Name:
If Ethernet is selected for Interface.
Select from the following method:
Specify External Device ID: Specify the External Device ID (0 to 31) of the upload source PLC. This is
External Device Name:
Specify IP Address:
Destination: Specify where to save the PLC program uploaded from the PLC connected to the MICRO/I. Select the
type of external memory: SD Memory Card
Location: Specify the location of the folder where the uploaded PLC program will be saved. The
A uploaded PLC program using the Data Transfer function is saved as a ZLD Project File(.zld).
*1 HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F only
*2 HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F/-5T, HG1G/1P only
*3 HG2J-7U only
8-128
Select the communication interface in which the MICRO/I is connecting
to the upload source PLC from serial interface or Ethernet. For details,
refer to Chapter 4 "Interface Configuration" on page 4-35.
Specify the slave number of the upload source PLC (0 to 31).
The name of the specified PLC is displayed here.
the External Device ID number set in the Project Settings dialog box,
on the Communication Driver Network tab.
The name of the specified PLC is displayed here.
Specify the IP address and port number of the upload source PLC.
maximum number is 247 characters. Only alphanumeric characters and symbols can be
used. Path delimiters and characters that cannot be used vary based on the model.
Model
HG2J-7U
HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F/-5T, HG1G/1P
Example: To save program to the folder "Uploaded_Program" in an external memory
device:
Uploaded_Program
WindO/I-NV4 User's Manual
*1
*2
, USB Flash Drive
, USB1
Delimiter
Characters that cannot be used
/
\
*3
*3
or USB2
.
" # $ & ' ( ) * : ; < > ? \ ` | ~
" * : ; < > ? |
Advertisement
Table of Contents
