User Communication Settings Procedure - IDEC WindO/I-NV4 User Manual

5.2 User Communication Settings Procedure

This section describes the procedure for setting user communication.
Create a new user communication protocol, and then configure it to a communication interface
●
Using Transmission Command and Receive Command
To use the commands for inching function with HG1P, refer to "Using Inching Function" on page 3-21.
1
On the Configuration tab, in the System Setup group, click Project.
The Project Settings dialog box is displayed.
2
Click the Communication Interface tab on the Project Settings dialog box.
3
Select the interface for user communication under Interface Configuration, and then select the user
communication in Function under Interface Settings.
HG2J-7U HG5G-V HG4G-V HG4G
WindO/I-NV4 User's Manual
5 User Communication
HG3G-V HG3G HG2G-V HG2G-5F
3
HG2G-5T HG1G HG1P
3-9