IDEC WindO/I-NV4 User Manual page 776

7 Alarm List Display
Options Tab
●
The Options tab is displayed in Advanced mode.
(Reference screen list)
■ Reference Screen
The Options tab is used to configure the reference screen. The reference screen is a base screen or popup screen
associated with each individual message. The reference screen is displayed when the key button Ref. is pressed.
1. Select a message displayed
on the Alarm List Display
Motor fault
Pump1 fault
High pressure
Pump1 fault
Select
Key buttons Up and Dwn
When displaying a reference screen, select either Base Screen or Popup Screen as the reference screen type.
When not displaying a reference, select Not Use.
This can only be set when New Message List has been selected in Message Settings on the General tab. When
Use Alarm Log Settings has been selected, the screen type will become the one selected in Reference Screen on
the Channel tab in the Alarm Log Settings dialog box.
■ Coordinates
X, Y: Specifies the coordinates to display the reference screen.
With the upper-left corner of the screen as the origin, the X and Y coordinates are the upper-left corner of the
reference screen.
This option can only be configured when Base Screen or Popup Screen is selected for Reference Screen.
Specify the coordinates in 1 dot units.
X: 0 to (base screen horizontal size - 1)
Y: 0 to (base screen vertical size - 1)
10-148
2. Press the key button Ref.
Up Down Reference
Key button Ref.
WindO/I-NV4 User's Manual
Motor fault
Pump1 fault
High pressure
Pump1 fault
Select Up Down Reference
Reference screen opens
Pump 1 fault
Motor fault
Pump 1 output low
Pump1 fault
Press Stop, check the air,
High pressure
Pump1 fault
then press Start.
Air Press.
Select Up Down Reference
0000
Stop Start
kg/m 2
Reference screen