Table of Contents
Advertisement
2 Multi-State Lamp
2.2 Multi-State Lamp Configuration Procedure
This section describes the configuration procedure for Multi-State Lamps.
1
On the Home tab, in the Parts group, click Lamps, and then click Multi-State Lamp.
2
Click a point on the edit screen where you wish to place the Multi-State Lamp.
3
Double-click the placed Multi-State Lamp and a Properties dialog box will be displayed.
4
Change the settings on each tab as necessary.
The Options tab only appears in Advanced mode.
You can set the default for the Multi-State Lamp on the Default Preferences tab of the WindO/I-NV4
Options dialog box. For details, refer to Chapter 2 "Default Preferences Tab" on page 2-63.
9-18
WindO/I-NV4 User's Manual
Advertisement
Table of Contents
