IDEC WindO/I-NV4 User Manual page 816

10 Numerical Display
Floating Digits:
*1
Floating Symbol :
Suppress Zeros:
Do not display when the value is zero:
• If the value is zero and it is not displayed, the unit set on the Format tab is also not displayed.
• Even if the Do not display when the value is zero check box is selected, "0" is displayed when the value is
not 0.
Display the minus sign:
Display the plus sign:
Symbol to show when out of range or Error occurs:
In the following cases, it is handled as an error and the symbol selected in Symbol to show when out of
range or Error occurs is displayed.
• If the Data Type is BCD4(B), BCD8(EB), or Float32(F) and the value entered in device address
doesn't comply with the data type.
• If a value divided by zero operation was executed with Display with Arithmetic Operation on the
Options tab.
*1 Advanced mode only
10-188
Specifies the number of digits for the fractional part of the decimal value out of the
number of digits specified by Digits.
This option can only be configured when the Display Floating Point check box is selected.
The range of digits that can be set for the fractional part varies based on the display type and
data type. The range of digits that can be set for the fractional part is as follows.
Display Type
UBIN16(W), BIN16(I)
UBIN32(D), BIN32(L)
Decimal display BCD4(B)
BCD8(EB)
Float32(F)
UBIN16(W)
Hexadecimal display
UBIN32(D)
Selects the decimal point symbol from the following.
.(dot), :(colon), ;(semicolon), ,(comma), /(slash)
This option can only be configured when the Display Floating Point check box is selected.
Example: When Digits is 4 and Floating Digits is 2
When Floating Symbol is .(dot)
When Floating Symbol is /(slash)
Select this check box to hide "0" for the upper digits of the integer part.
Example: Suppress Zeros selected:
Suppress Zeros cleared:
Select this check box to show a blank display if the value is "0".
Select this check box to display the - (negative) sign when displaying negative values.
This option can only be configured when Decimal is selected for Display Type.
Select this check box to display the + (positive) sign when displaying positive values.
This option can only be configured when Decimal is selected for Display Type.
Selects the following symbols to be displayed when a value exceeding the Data Type in
the General tab is entered, or an error occurs.
"? (question mark)", " (space)", "# (pound)", "% (percent)", "$ (dollar)", "- (minus)",
"@ (at sign)", "\ (backslash)", "* (asterisk)", "! (exclamation mark)", "+ (plus)"
WindO/I-NV4 User's Manual
Data Type
1 to Digits
1 to Digits
1 to Digits
1 to Digits
1 to Digits or 8
12.34
12/34
1234
00001234
Floating Digits
--
--