IDEC WindO/I-NV4 User Manual page 130

5 User Communication
4
Specify the items for Interface Settings.
The settings vary based on the interface.
*1
■ Serial Interface
 For details, refer to Chapter 4 "When SERIAL1(RS232C), SERIAL1(RS422/485), COM(RS232C), or
COM(RS422/485) is selected under Interface Configuration" on page 4-40.
■ Ethernet Interface
 For details, refer to Chapter 4 "When Protocol1 to Protocol7 is selected for Ethernet under Interface
Configuration" on page 4-43.
5 Click the User Communication tab.
6 Enter the name of the user communication protocol that will be set in Protocol Name.
The maximum number for protocol name is 40 characters.
You cannot use the following characters in the protocol name.
" * , / : ; < > ? \ |
*1 Only special product is equipped with a serial interface (RS232C).
*2 This is applicable for models with an ethernet interface only.
3-22
*2
WindO/I-NV4 User's Manual