Table of Contents
Advertisement
Registering Constant (Hexadecimal)
From the registered hexadecimal data, the hexadecimal data according to the value of device address is read and
transmitted.
This can be configured only when TXD or Inching is selected as Type on the Command Settings dialog box, and
Registering Constant (Hexadecimal) is selected under Type on the Data Settings dialog box.
■
Number of Registering Constants
Specify the number of data of the registered hexadecimal data (1 to 100).
■
Registering Constants
No.:
Shows the ID No. (1 to 100) of the hexadecimal data.
Index:
Shows the Index No. of the hexadecimal data.
Data:
Shows the hexadecimal data.
■
Index
Specify the Index No. (0 to 65535) of the hexadecimal data.
■
Data
Enter the hexadecimal data (1 to 1500 bytes) to be registered.
The data of different size or the same data with a different number cannot be registered.
Set
■
Register the Index and Data settings to the list. When a number that is already registered is selected, it is
overwritten with the new setting.
■
Insert
Insert a hexadecimal data setting to the selected number in the list.
Click this button to insert the Index and Data setting. The settings at the insertion point shift down one line. Settings
cannot be inserted when all numbers are already set.
■
Delete
Delete the selected settings from the list.
■
Index Device Address
Specify the source word device to serve as the Index No. You can only specify an internal device.
Click
to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2 "5.1 Device
Address Settings" on page 2-70.
WindO/I-NV4 User's Manual
5 User Communication
3
3-57
Advertisement
Table of Contents
