Table of Contents
Advertisement
2 Alarm Log Function Configuration Procedure
2
Alarm Log Function Configuration Procedure
This section describes the configuration procedure for the Alarm Log function.
2.1 Configuring the Device Addresses to Monitor and the Alarm Detection Condition
1
On the Configuration tab, in the System Setup group, click Alarm Log.
The Alarm Log Settings dialog box is displayed.
2
Select the type of device address to monitor under Source Device Address Type on the Channel tab.
If you select Word, device addresses are configured per block.
If you select Bit, device addresses are configured per channel.
3
Set the number of blocks to manage in Number of Blocks.
1 channel is used for 1 device address to monitor. 1 block is 16 channels.
The number of blocks that can be set varies based on the Source Device Address Type setting and the model.
4
Select the reference screen type in Reference Screen.
The reference screen is associated with the channel. This screen is displayed when the key button Ref. is pressed.
If a reference screen is not displayed, select Not Use.
5
To batch register all channels, click Auto. To individually register each channel, click Edit.
An example when Auto is clicked is described here.
The Auto-Setup dialog box is displayed.
13-10
HG2J-7U
HG5G-V HG4G-V
HG4G
WindO/I-NV4 User's Manual
HG3G-V
HG3G
HG2G-V
HG2G-5F
HG2G-5T
HG1G HG1P
Advertisement
Table of Contents
