Table of Contents
Advertisement
3 Project Settings Dialog Box
■
Screen Number Format
Selects the type of data to use for the System Area 1 Display screen number (address number+0) as BCD or BIN.
Default Screen: Specifies the screen number of the base screen to display first when the MICRO/I is turned on (0 to
3000). When 0 is specified, the MICRO/I is in the screen waiting state. Write a screen number to
System Area 1 Display screen number (address number+0) or specify the default screen number
from 1 to 3000.
■
Backlight
These options configure the backlight control function.
Auto OFF:
Halve the Brightness: Select this check box to lower the backlight brightness when the MICRO/I is unused for an
Light ON with Screen Changing:
■
Enable Touch Sound
Select this check box to play a sound when the screen is pressed.
*3
(Touch sound)
:
Control by Device Address:
*2 HG1P only
*3 This is applicable for HG2J-7U and models with an audio interface only.
*4 When the Sound File is selected, the sound is the same whether the device address is set to 1 or 2.
4-26
Select this check box to turn off the backlight when the MICRO/I is unused for an extended
period of time. To turn on the backlight, touch the screen or the function keys
System Area 1 Backlight auto off bit (address number+1, bit 5) or System Area 1 Backlight bit
(address number+1, bit 0).
Time (min): Specifies the time (1 to 9999) from when the MICRO/I is last used to when the
backlight is turned off.
extended period of time. To return to the backlight to its original brightness, touch the screen
or write 1 to System Area 1 Backlight bit (address number+1, bit 0).
Time (min): Specifies the time (1 to 9999) from when the MICRO/I is last used to when the
backlight brightness is lowered.
When the backlight is turned off or when the backlight brightness has been lowered with the
backlight control function, select this check box to turn on the backlight or restore the
backlight brightness when the screen is switched.
This option can only be configured when the Auto OFF check box or the Halve the
Brightness check is selected.
These options select the touch sound.
These options can only be configured when Enable Touch Sound is selected.
Beep Sound:Plays a beep (electronic sound).
Sound File: Plays a sound file.
Sound ID:
Select this check box to control the touch sound with a value of device address.
(Device Address): Specifies the word device that controls the touch sound.
WindO/I-NV4 User's Manual
Configures the sound file to play as the touch sound.
Click
to display the Sound Settings dialog box. For the
sound file configuration procedure, refer to Chapter 21 "To play
a sound file as a touch sound instead of a beep." on page 21-3.
Click
to display the Tag Editor. For the device address
configuration procedure, refer to Chapter 2 "5.1 Device
Address Settings" on page 2-70.
The control over a touch sound with a value of device address
is as follows.
0: Do not play the touch sound.
1: Play the touch sound.
*4
2: Play a shortened
touch sound.
*2
, or write 1 to
Advertisement
Table of Contents
