Table of Contents
Advertisement
3 Project Settings Dialog Box
3.14 E-mail Tab
You can set the outgoing mail server (SMTP) to be used for sending an e-mail from MICRO/I. For details, refer to
Chapter 28 "4 E-mail Function" on page 28-38.
■
General Setting
Outgoing mail server (SMTP):
If Host Name is selected, the IP address of the outgoing mail server (SMTP) is looked up and obtained from
the host name using the DNS server. In order to access a DNS server from the MICRO/I, the IP address of
the DNS server must be specified. For details, refer to " When Ethernet is selected under Interface
Configuration" on page 4-41.
Outgoing mail server (SMTP) port number:
The outgoing mail server (SMTP) port number to use varies based on the server. For details, contact the
administrator of the network which the MICRO/I is connected to.
Normally, port number 25 for SMTP, and port number 587 for SMTP-AUTH are used.
4-70
HG2J-7U
HG5G-V HG4G-V
Selects the Outgoing mail server (SMTP) setting method.
Host Name:
Specifies the Host Name of the outgoing mail server (SMTP).
The maximum number is 40 characters. Only alphanumeric characters,
-(dash) and .(period) can be used.
IP Address:
Specifies the IP address of the outgoing mail server (SMTP).
The format is "xxx.xxx.xxx.xxx". "xxx" stands for a numeric value from
0 to 255.
Specifies the port number for the outgoing mail server (SMTP) (0 to
65535).
WindO/I-NV4 User's Manual
HG4G
HG3G-V
HG3G
HG2G-V
HG2G-5F
HG2G-5T
HG1G HG1P
Advertisement
Table of Contents
