Properties Of Goto Screen Command Dialog Box - IDEC WindO/I-NV4 User Manual

3 Goto Screen Command

3.3 Properties of Goto Screen Command Dialog Box

This section describes items and buttons in the Properties dialog box.
General Tab
●
■ Part Name
Enter a name for the part. The maximum number is 20 characters.
Action Mode
■
Select the action to perform when the trigger condition is met from the following:
Back to previous Screen:
Switch to Base Screen:
Open Popup Screen:
Close Popup Screen:
Open Device Monitor Screen:
Close Device Monitor Screen:
Open Password Screen:
Close Password Screen:
Open Adjust Brightness Screen:
Close Adjust Brightness Screen:
12-20
Switches to the previous screen. Returns to up to 16 earlier screens.
Switches between Base Screen. For details, refer to Chapter 5 "3 Base Screen"
on page 5-14.
Opens a Popup Screen. For details, refer to Chapter 5 "4 Popup Screen" on page
5-20.
Closes a Popup Screen. For details, refer to Chapter 5 "4 Popup Screen" on page
5-20.
Opens the Device Monitor Screen. For details, refer to Chapter 25 "2.2 Device
Monitor" on page 25-21.
Closes the Device Monitor Screen. For details, refer to Chapter 25 "2.2 Device
Monitor" on page 25-21.
Opens the Password Screen. For details, refer to Chapter 23 "4.1 Entering the
Password on the MICRO/I" on page 23-47.
Closes the Password Screen. For details, refer to Chapter 23 "4.1 Entering the
Password on the MICRO/I" on page 23-47.
Opens the Adjust Brightness Screen. For details, refer to Chapter 34 "1.3
Adjusting Screen Brightness" on page 34-2.
Closes the Adjust Brightness Screen. For details, refer to Chapter 34 "1.3
Adjusting Screen Brightness" on page 34-2.
WindO/I-NV4 User's Manual