Table of Contents
Advertisement
4.2 Meter Configuration Procedure
This section describes the configuration procedure for meters.
1
On the Home tab, in the Parts group, click Charts, and then click Meter.
2
Click a point on the edit screen where you wish to place the Meter.
3
Double-click the placed Meter and a Properties dialog box will be displayed.
4
Change the settings on each tab as necessary.
The Range tab, Scale tab and Options tab only appear in Advanced mode.
You can set the default for the Meter on the Default Preferences tab of the WindO/I-NV4 Options
dialog box. For details, refer to Chapter 2 "Default Preferences Tab" on page 2-63.
WindO/I-NV4 User's Manual
4 Meter
11
11-65
Advertisement
Table of Contents
