Table of Contents
Advertisement
3 Project Settings Dialog Box
Device Addresses for General Setting and Authentication Setting
When the Specify General setting and Authentication setting by Value of Device Address check box is
selected, it allocates the settings of the General Setting and the Authentication Setting starting at the device
address set in the Top Device Address. The details are shown below.
Outgoing mail server (SMTP)
Outgoing mail server (SMTP) port number
Sender E-mail Address
Sender Name
Require authentication (LOGIN) to send E-mail
(0: Not require authentication,
1: Require authentication)
Account Name
Password
Use secure connection (SSL/TLS)
(0: Disable, 1: Enable)
String data is stored in the upper byte and lower byte according to the Storage Method of String Data
setting. For details, refer to "Storage Method of String Data" on page 4-29.
*1 When IP address is selected, use only four words from the beginning, and the remaining seventeen words are left as a
reserved area.
*2 The twenty-first word is recognized as a NULL terminating character (0x00) regardless of the value of device address.
*3 Add a NULL terminating character (0x00) as the end of the string data when the string length is less than twenty words.
4-72
Settings
WindO/I-NV4 User's Manual
Address Number
Words
*1, *2
+0 to +20
21
+21
1
*2, *3
+22 to +42
21
*2, *3
+43 to +63
21
+64
1
*2, *3
+64 to +85
21
*2, *3
+86 to +106
21
+107
1
Data Format
Host Name is selected: String
IP Address is selected: Decimal
Decimal
String
String
Decimal
String
String
Decimal
Advertisement
Table of Contents
