Table of Contents
Advertisement
1 Bar Chart
1.2 Bar Chart Configuration Procedure
This section describes the configuration procedure for bar charts.
1
On the Home tab, in the Parts group, click Charts, and then click Bar Chart.
2
Click a point on the edit screen where you wish to place the Bar Chart.
3
Double-click the placed Bar Chart and a Properties dialog box will be displayed.
4
Change the settings on each tab as necessary.
The Data Over tab, Scale tab, Label tab, Trigger Condition tab and Options tab only appear in
Advanced mode.
You can set the default for the Bar Chart on the Default Preferences tab of the WindO/I-NV4 Options
dialog box. For details, refer to Chapter 2 "Default Preferences Tab" on page 2-63.
11-2
WindO/I-NV4 User's Manual
Advertisement
Table of Contents
