IDEC WindO/I-NV4 User Manual page 446

2 Word Button
■ Destination Device Address
Destination Device Address:
Use Reference Device Address
*1
:
Write
*1 Advanced mode only
8-26
Specify the destination word device.
Click to display the Tag Editor. For the device address configuration procedure,
refer to Chapter 2 "5.1 Device Address Settings" on page 2-70.
*1
: Select this check box and specify a device address to change the destination word
device according to the value of the specified device address.
This setting is enabled only if Action Mode is set to Move.
For details, refer to Chapter 2 "Indirect Read and Indirect Write Settings" on page
2-5.
Specify the number of word devices (1 to 64) at the destination.
For Move, specify how many times to write.
This setting is enabled only if Action Mode is set to Set, Momentary,
Alternate, or Move.
Example: If Data Type is set to UBIN16(W) and Write is set to 5, the same
data will be written to 5 continuous word addresses.
Data Type: UBIN16(W)
Source Data: 12345
Destination Device Address: LDR10
Write: 5
Example: If Data Type is set to UBIN32(D) and Write is set to 5, the same data
will be written to a total of 10 word addresses (2 words 5 times).
Data Type: UBIN32(D)
Source Data: 987654
Destination Device Address: LDR10
Write: 5
WindO/I-NV4 User's Manual
LDR10 12345
LDR11 12345
LDR12 12345 5 words
LDR13 12345
LDR14 12345
LDR11 LDR10
987654
LDR13 LDR12
987654
LDR15 LDR14
987654 10 words
LDR17 LDR16
987654
LDR19 LDR18
987654