IDEC WindO/I-NV4 User Manual page 976

6 Multi-Command
*4
Copy Files is selected.
Source:
Select the source external memory: SD Memory Card
Location: Specify the location of the file to be transferred. The maximum number is 247 characters.
Destination: Select the destination external memory: SD Memory Card
USB2
Location: Specify the location where the file will be transferred. The maximum number is 247
• If a file name is specified as the source location, the specified file is copied.
If a folder name is specified, all of the files and subfolders contained in the folder, and all of the files in
the subfolders, are copied.
• The subfolders can be copied up to five levels.
• To prevent copying the subfolders and the files contained in the subfolders, HMI Special Internal Relay
LSM30 must be set to 1 before executing the copy.
• To stop copying files during the copy operation, write 1 to HMI Special Internal Relay LSM31. However, it
will continue to copy the file until it is finished then it will stop copying.
*1 HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F only
*3 HG2J-7U only
*4 HG2J-7U, HG5G/4G/3G/2G-V, HG4G/3G , HG2G-5F only
12-52
Only alphanumeric characters and symbols can be used. Path delimiters and characters that
cannot be used vary based on the model.
HG2J-7U
HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F
Example: Copy a file "Error.wav" to the root directory of an external memory device:
Error.wav
*3
.
characters. Only alphanumeric characters and symbols can be used. Path delimiters and
characters that cannot be used vary based on the model.
HG2J-7U
HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F
Example: Save a file to the "SOUND" folder under "HGDATA01" folder in an external
memory device:
HG2J-7U:
HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F:
WindO/I-NV4 User's Manual
*1
, USB Flash Drive
Model Delimiter
*1
Model Delimiter
HGDATA01/SOUND
*1 *3
, USB1
Characters that cannot be used
/ " # $ & ' ( ) * : ; < > ? \ ` | ~
\ " * : ; < > ? |
*1
, USB Flash Drive , USB1
Characters that cannot be used
/ " # $ & ' ( ) * : ; < > ? \ ` | ~
\ " * : ; < > ? |
HGDATA01\SOUND
*3
or USB2 .
*3
or