Auto Control Panel: Applying Welding Programs - Kemppi X5 FastMig Series Operating Manual

Water cooler
Weld data duration
Date
Time
Language
Factory reset
Safe wire inch
(with MIG only)
Cable calibration
(with MIG only)
VRD
(with MMA and gouging only)

3.3.8 Auto control panel: Applying welding programs

Use the welding program that is in accordance with your welding setup (e.g. welding wire and gas properties).
The use of additional welding programs and Wise features is possible with the X5 FastMig Synergic equipment in MIG
operation mode.
1. Go to the Memory channels view. (Refer to "Auto control panel: Memory channels" on page 70 for more inform-
ation.)
2. Enter the actions menu.
3. Select Create channel.
>> A filter view opens.
© Kemppi
OFF/Auto/ON
Default = OFF
0 ... 30 s, step 1
0 = OFF
Default = 5 s
Current date
Current time
Available languages
Reset/Cancel
Default = Cancel
OFF/ON
Start/Cancel
OFF/12V/24V
Default = OFF
79
Operating manual - EN
When ON is selected, the coolant is cir-
culated continually, and when Auto is
selected, the coolant is circulated only dur-
ing welding. The Auto mode is available
only with welding guns supporting the
automatic detection.
This defines if and how long the weld data
summary is shown after each weld.
When ON, and the arc doesn't ignite, the
filler wire is fed 5 cm When OFF, 5 m of filler
wire is fed.
The date and time and the calibration
information of the previous calibration is
also shown.
Refer to "Calibrating welding cable" on
page 62 for cable calibration.
Voltage reduction device (VRD) reduces
the open-circuit voltage to maintain below
a certain voltage value.
X5 FastMig
1920960 / 2039