Table of Contents
Advertisement
1.2.1 Wire feed mechanism
1.
Drive rolls and drive roll mounting caps
2.
Middle guide tube locking clip
3.
Middle guide tube
4.
Inlet guide tube
5.
Pressure handles
6.
Pressure rolls and pressure roll mounting pins
7.
Pressure roll locking arms
8.
Outlet guide tube.
For replacing the feed rolls, refer to "Installing and replacing feed rolls" on page 21.
For replacing the wire guide tubes, refer to "Installing and replacing wire guide tubes" on page 23.
1.2.2 Control panel
This section describes the controls and features of the Master M 358 control panel (TFT/LCD).
1.
Left control knob (with push button function)
2.
Right control knob (with push button function)
3.
Memory channel selection (shortcut button)
4.
View selection (shortcut button)
5.
Welding parameters view (shortcut button).
© Kemppi
9
Master M 358
Operating manual - EN
1921980 / 2240
Advertisement
Table of Contents
