Installing Equipment On Cart (Optional) - Kemppi MasterMig 353 Operating Manual

2.3 Installing equipment on cart (optional)

MasterMig has four transport unit options: a 4-wheel cart with a gas bottle rack (P45MT), a 4-wheel cart without a gas
bottle rack (P43MT), a 2-wheel cart with a gas bottle rack (T25MT) and a 2-wheel cart without a gas bottle rack (T35A).
The equipment installation principle and the bottom securing interface is the same with all carts.
Tools needed:
1. Install the cooling unit on the cart.
2. Fix the cooling unit to the cart with two screws (M5x12) in the front and two screws (M5x12) in the rear.
3. Install the MasterMig device on top of the cooling unit. Refer to "Installing cooling unit (optional)" on page 13 for
installation details.
4. T25MT 2-wheel cart: Secure the equipment to the cart with the two side connection brackets.
With the T25MT cart, an additional securing bracket is attached to the device handle. Secure the bracket to the cart
with the screws provided (M8x16) .
© Kemppi
15
MasterMig 353, 355
Operating manual- EN
1921960 / 2217