4-4.
REMOUNTING EEPROM
NOTE
If the PW Board has replaced, be sure to remount EEPROM from the old to new PW Board.
If the PW Board has been replaced and EEPROM has not been remounted, be sure to
replace the PC Drum with a new one. EEPROM contains no data in this case, so make
entries again of numeric values given on the Adjust Label.
(1)
Remounting EEPROM on the Master Board
1. Remove the Master Board.
2. Remove EEPROM (IC101) from the new Master Board.
3. Remove EEPROM (IC101) from old Master Board and remount it onto the new Master
Board.
A
NOTE
Note the alignment notch (A) on EEPROM (IC101)
when mounting the IC.
4002D530AA
D-123
4002D529AA